[. . . ] Disconnect the appliance from the mains as soon as a fault is detected. Any repairs, such asreplacing a damaged power cable, may only be carried out by our Customer Services team in order to avoid potential danger. The T DISC, the piercing unit and the beverage outlet may be very hot immediately after brewing. [. . . ] The float in the water tank is Clean the water tank and free the float. The brewing will not start and/or The status display LED lights up red. The displays/buttons for drink intensity, drink temperature and drink size are flashing. Smooth out the foil of the T DISC with your finger so that the bar code can be read. Clean the brewing unit with a soft, damp cloth, paying particular attention to the lid area. Check that the appliance is plugged into the power supply before inserting the T DISC. The piercing unit and/or the T DISC support have not been correctly inserted. Press the piercing unit into its holder using both thumbs and check the position of the T DISC support. Place the T DISC with the printed side facing downwards so that the tab is resting in the intended slot. Clean the brewing unit with a soft, damp cloth, paying particular attention to the lid area. When closing the brewing Press the lid down until it audibly clicks Unit, a slight resistance must into place. Only open the brewing unit when the status display has stopped flashing and remains lit continuously. Wait until the brewing stage has come to an end and the appliance has cooled down. Press the piercing unit into its holder using both thumbs (until an audible click is heard). Condensation may appear and is not caused by any fault with the appliance. The recommended volume for During the brewing process, press the This Start/Stop button to interrupt this stage. Press and hold the Start/Stop button until Build-up of limescale in the appliance could cause reduced quantity. Fill up the tank after making a drink and press the Start / Stop button. [. . . ] En Guarantee The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. Details regarding these conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee. [. . . ]